TSM L steel zinc-plated screw anchor with pan head and TX drive
Screw anchor with pan head TSM L 6x28 P TX30
Drill - screw in - done
Register now and access more than 40'000 products
Drill - screw in - done
The screw anchor is an innovative fastening system for securing assembly parts to concrete and other solid masonry. With its cutting-teeth design, the screw anchor cuts a thread in the drill hole as it is screwed in, creating a connection with mechanical interlocking and no expansion pressure. The extra-short design avoids the need for reinforcing bars and can be installed extremely quickly.
Advantages:
- Shallow drill hole depths and small drill hole diameters
- Cutting teeth at the front of the anchor ensure minimal tightening torque
- No expansion effect, therefore minimal spacing and edge distance
- Quick and simple in-place installation, can be easily inserted by mechanical means
- Immediate load-bearing capacity - no waiting
- Fastening can be fully removed again
- No torque control required
- Wide range of uses due to numerous versions
- Attractive appearance
Advice:
Screw in with a cordless screwdriver or ratchet. The use of a tangential impact driver is not permitted!
Datasheets(X)
 | |
Anchor size | 6 |
Anchor length (l) | 28 mm |
Thread diameter | 7.5 mm |
Nominal drill-bit diameter (d 0) | 6 mm |
Surface | Zinc plated |
Material | Steel, case-hardened |
Head diameter | 17.5 mm |
Select RAL-colour code
!! NOTE: On-screen visualisation of the colour differs from real colour shade!!